PE1955 Chassis temperature sensor values change - Power and Cooling - Forum - Power and Cooling - Dell Community

PE1955 Chassis temperature sensor values change

Power and Cooling

Power and Cooling
Dell Power and Cooling on Dell TechCenter. Fresh Air, OpenManage Power Center, PDUs, Power Saving Best Practices and more.
Generic Content

PE1955 Chassis temperature sensor values change

  • is there a way to change the default values for temperature sensor on power edge 1955 chassis?
  • Hello mkchain,

    you can modify the values via open manage server administrator tool, at http://support.euro.dell.com/support/edocs/software/svradmin/6.1/en/CLI/HTML/config.htm#wp1093458 you can find the omconfig command to change the value, its also possible to add an event in case the temp sensor is too high (in example to power down the server), ths can be perofmed with the omconfig command, please note that the open manage tool needs to be installed on server, you can also create small batches or scripts to execute the commands and actions, warnings can also be checked and sent by DRAC card, the docs for usage can be found at http://support.euro.dell.com/support/edocs/software/smdrac3/dracmc/1.3/en/index.htm
    all infos are taken off the the open manage server administrator tool version 6.1 docs, please also verfiy your used operating system, compatibilty of used operating system on blade as well as needed updates (firmware, drivers, etc.), if unsure yxou can also engange the technical support for clarify or post next questions here

    Best regards

    Marcus