Browse by Tags

Networking

Networking
Learn how to modernize & transform the network with the latest solutions from Dell Data Center, Campus and Wireless networking solutions.
Results for VLAN
  • PowerConnect 6248P Multicast Question

    Sorry if this has been asked many times before, I have been doing some searching and have not found an answer to this exact question yet. I have a few schools with a PowerConnect 6248P as my layer 3 switch, we have a student 1:1 laptop program and are looking to roll out LanSchool which is a student...
  • Power Connect 6224 Vlan Routing Configuration

    Hello people, I am new with Dell switches. I have the following scenario: vlan 10 - 192.168.0.1 /24 vlan 20 - 192.168.1.1/24 FIREWALL - ASA - IP 10.0.0.1 I need to configure routing beetwen this vlans and If the switch receives a packet for a network not in the routing table, it forwards to my Firewall...
  • Powerconnect 70xx / LLDP-MED / Polycom Phones

    Has anyone successfully provisioned a Polycom cx600 Lync phone using LLDP-MED to assign vlan? If so, what settings to use? When I view the LLDP statistics, I can see that the switch is recognizing the device and even giving it the proper vlan assignment but when the phone boots up it usually shows up...
  • PC 6248 L3 Switch Routing to ISP

    And I was wondering if somebody could please help me? We recently sign up for FPL FiberNet Direct Internet Access (DIA), and they provide us with a point-to-point /30 IP for connection between our Fiber-to-copper Transceiver and the NOC and also gave us a block of /28 public IPs that we have to...
  • Routing between PowerConnect 6248P Stack and 8024F

    Hi All, We are about to change our network topology due to some latency issues and wanted some advice on routing between multiple subnets and VLANs across a single 10Gb private ethernet line. We have a stack of PowerConnect 6248P switches with 3 VLANs and the corresponding subnets that we would...
  • PowerConnect 6224 vlans configure

    Hi all, I’m looking for the best practices on routing a bunch of subnet and setup windows failover with hyper- v , so look my setting I have MD3200i and 2 server R720 also Stacking 4 PowerConnect 6224 and try to create cluster failover but went a try to run the iscsi initiator doesn’t...
  • VLAN - Separating Guest network from production

    Hello all, I'm trying to create a VLAN that will separate the internet traffic for a guest network. Currently we have a single switch with default vlan 1 and I created VLAN 200. Assigned IP address and (2) ports to this VLAN. One port is DHCP server with a separate scope that is tied to this subnet...
  • Dell 6224 VLAN and Routing

    Trying to create a simple mockup network config to simulate an upcoming project that will connect several 6224's via WAN Layer 2 ethernet. My basic setup is as follows; VLAN100 - Data 192.168.1.0/24 VLAN 101 - Voice 192.168.2.0/24 VLAN 102 - Secure 192.168.3.0/24 To really keep it simple...
  • VLAN configuration to isolate gateway

    I have not done a lot with VLANs, and I am having a bit of an issue configuring my network correctly. I am hoping someone out there will have a simple solution for me. The WAP I have provides multiple SSIDs and MAC addresses to go with the SSIDs. Each SSID/MAC pair can have a unique zone attached...
  • 2 vlans with ACLs what am I missing

    Thanks for reading. This topology consists of one 6224 and two 2824 Powerconnect switches. Right now, we're looking to build two VLANs, routed, sharing a small range of IPs on VLAN 20. Also want to route out to the interwebz for both nets. Do I need a third vlan for that? Presumably one...
  • Split 5424 for iSCSI and management...

    Hello experts! I have a pair of PC5424's and intend to connect them between my EMC Celerra and my R710 ESXi hosts for iSCSI. My main concern is to get our iSCSI traffic off of the LAN and to eliminate any single points of failure between our hosts and storage. I have read through the forums and...
  • Performance trouble, any troubleshooting advice?

    Hi, We recently made the following changes in our LAN 1) Purchase an L2 connection between our two sites from the ISP 2) Stretched iSCSI VLAN between the two sites for replication Previously our ISP provided a VPN service between the two sites. But since we are improving our DR setup we wanted...
  • two 8024-k and a Catalyst 6509

    Hi, I'm at loss which configuration pattern I should use on a M1000e with two 8024-k's connected to a Catalyst 6500. This is for use with ESX, and vlan tagging is necessary and redundancy, the storage is iSCSI SAN. Could someone point me at the most appropiate configuration examples...
  • 6224 Bind IP Subnet to VLAN

    How does the BIND IP SUBNET TO VLAN operate? Will it allow us to configure several VLAN's on a single switch and then utilize the built in Layer 3 functionality to move the packets to like VLAN's on other switches via TRUNK Ports?
  • How to setup WOL in a routed environment

    Hi, We have a routed environment based on Powerconnect 6224 switches and we are wondering if it is possible to allow WOL requests over all VLANs? We are using the K2000, which allows WOL and we'd like to use this functionality. Wouter
  • Issues with an 8024

    Howdy all. So I inherited a datacenter with some half-baked Dell switches in it. In an effort to straighten the joint up a bit, I dove into the switches to tighten up the VLANing, shutdown unnecessary STP, tune iSCSI, etc. What I found inside of this switch is a huge learning curve for me. I'm a...
  • Dell-8132-Switch-routing

    Dell-8132-Switch-routing Dell Sonic Wall Default gateway :192.168.0.254 Dell 8132 Switch * 2 stacking vlan 1 : 192.168.0.0/24 (Default VLAN) vlan 10 : 192.168.10.0/24 vlan 20 : 192.168.20.0/24 vlan 1 SVI : 192.168.0.250 vlan 10 SVI : 192.168.10.250 vlan 20 SVI : 192.168.20.250 ip routing &...