Dell PowerVault TL2000 - Media Attention

Storage

Storage
Information and ideas on Dell storage solutions, including DAS, NAS, SAN and backup.

Dell PowerVault TL2000 - Media Attention

This question is not answered

Hello All,

Finished installing my brand new PowerVault TL2000.

Unfotunately during the first backup we had a major power loss and the library was powered off unexpectedly.

Since then the led of the media attention is on and the system status shows "Media attention" with a yellow exclamation mark.

Steps I took :

I run the diagnostic tool and it finished with no errors.

Run the advanced diagnostic tool and it too finished with no errors.

Went through the the logs and the drive logs - all clear.

Rebooted the ilbrary - no help.

I can access the library via the backup software (BE12.5) and run backup jobs.

Oddly Backups runing fine...

You help is appreciated.

All Replies
  • You should be able to view the Inventory of the library via the RMU to determine which tape is "bad". Remove that tape from the library and that should clear out the Media Attention.

     

    From the RMU select Monitor Library / Inventory then expand the cartridge details for each magazine... this should show you the media in question.

     

    Hope this helps... Bob

  • Hi,

    I am having a similar problem with the media warning alert. All services are running correctly and there are no connectivity issues.

    Also, through using the RMU, I can see the details for each magazine and none of the media are showing any problems.

    Our media attention alert appeared at the same time that a routine clean was needed. We ran clean service, but cannot get the media alert to disappear from the RMU. It has since gone from BackupExec.

    Any help would be great,

    Regards,

    Rory

  • Hello Rory,

    Since you say that they media attention light came on after your last cleaning have you changed your cleaning tape?  I know you stated that you checked the magazines in the RMU and didn’t see any media that had any errors.  Also if you setup the auto clean & cleaning slot you need to reduce your available slots by 1 from 24 to 23.  Also if you have setup the I/O slot then you will need to reduce your available slots by 1 as well.  To reduce the slots you can change it in the RMU by going to Configure Library MenuGeneral.  

    Please let us know if you have any other questions.

    Sam L.

    Dell | Social Outreach Services - Enterprise

    Download the Dell Quick Resource Locator app today to access PowerEdge support content on your mobile device! (iOS, Android, Windows)