PCIe Trining Error: Embedded NIC 3

Servers

Servers
Information and ideas on Dell PowerEdge rack, tower and blade server solutions.

PCIe Trining Error: Embedded NIC 3

This question is not answered

Greetings,

The server R710 had a prolonged power outage. When the power came back on the system booted and was then halted for a

"PCIe Training Error: Embedded NIC 3"

I read other posts on this  but they all involved PCI BUS and Cards and their solutions did not pertain because the error involves an embedded component.

I cannot get in to the BIOS because of the System Halt. Is the anyway I can bypass this error or disable the Training Error reporting altogether?

Thank you for any response.

Keith

All Replies
  • Keith,

    The PCIe Training Error: Embedded NIC 3 error is generally referring to the motherboard being damaged.

    Would you take the server to a Minimum to Post  configuration, that is removing everything but the following devices;

    System board

    Risers

    Processor (CPU1) with Heatsink

    Power Supply

    One stick of memory in DIMM slot A1

    Control Panel w/cable

    After that then we need to clear the NVRam. You do this by finding the jumper between the dimm bank and the power supplies and moving the jumper to the other pin and then power up the server. After that then power down and restore the jumper. Then power the server to see if it will complete post.

    If the server fails to complete post under that configuration then it is likely the board is damaged.

    Chris Hawk

    Dell | Social Outreach Services - Enterprise
    Get Support on Twitter @DellCaresPro 
    Download the Dell Quick Resource Locator app today to access PowerEdge support content on your mobile device! (iOS, Android, Windows)

  • I did all that you asked and the same error came up.

    I noticed on boot that NIC 3 and NIC 4 were disabled. They are not needed for my server. Is there a method of bypassing the error "Those LAN ports are not required" or do I need to replace the entire motherboard?

    Thanks for the quick response

    Keith

  • Keith,

    If you can't access the BIOS then you can't disable the ports, if you could reach the BIOS then you can go to Integrated Devices - Then disable NIC port 3 and 4.

    Without being able to access the BIOS you will need to replace the motherboard for the server.

    Chris Hawk

    Dell | Social Outreach Services - Enterprise
    Get Support on Twitter @DellCaresPro 
    Download the Dell Quick Resource Locator app today to access PowerEdge support content on your mobile device! (iOS, Android, Windows)