Monitor Arm MSA14 - Adjusting? - Monitors Forum - Peripherals - Dell Community

Monitor Arm MSA14 - Adjusting?

Peripherals

Peripherals
Dell Monitors, Printers, Projectors, Hardware and Software discussion

Monitor Arm MSA14 - Adjusting?

This question is not answered

Just spent 30 minutes on the phone trying to get to tech support for help in adjusting this monitor arm and I was disconnected.  I'm not sure where or how you adjust the weight so the arm goes down as shown in the diagram.  Any help would be appreciated.

Thank you.

All Replies
  • Hi lawzee,

    I regret for the inconvenience caused. To check how to adjust the monitor arm, you may refer to the manual on the arm adjustment settings. Please refer to the link: http://bit.ly/1cImmxW.

    Hope this helps. Please feel free to reply for further assistance.  

    Thanks & Regards
    Amogh G
    #iworkfordell
    To know more about Dell Product Support, Drivers & Downloads, Order & Dispatch status -> choose your region USAIndia. For helpful Dell Support Videos, you may click Here

  • I have this manual - but the pictures are not clear.  Is there a video or something more detailed that shows where the adjustments and how the adjustments are made?

    Thank you.

  • Hi lawzee,

    I tried to find out a video regarding mounting the monitor on the arm. Unfortunately, I am not able to find something relevant.

    Please feel free to reply for any further assistance. I will be glad to assist you.

    Thanks & Regards
    Amogh G
    #iworkfordell
    To know more about Dell Product Support, Drivers & Downloads, Order & Dispatch status -> choose your region USAIndia. For helpful Dell Support Videos, you may click Here

  • I have the MSA14 articulating monitor arm. The upper arm articulations do not move except for the one closest to the monitor. I have viewed the video and wriiten instructions - no tension adjustment is indicated. I will appreciate hearing from anyone who has experience with this product.

  • I just got one of this dell arms, and I was puzzled too, because the manual show an adjustment screw that I coudnt find in the arm. The thing is, you have to install the display first, with the arm extended the way it came, and then force it down. It will be a little hard, but it will go down. Then you will be able to see the adjustment screw on top of the arm joint. After that, use the alllen tool to adjust the arm. It will be very easy to adjust the height after this.

    Hope this helps anyone with the same problem.

  • wow, thanks a lot man, you are a genius, you save me from frustration and customer support dont have a clue

  • Hi there

    This arm should articulate in two hinges as the manual shows. This advice is good for the hinge closest to the monitor mount but the hinge in the middle should also be able to drop down but it doesn't. No amount of pressure will make it move. There is no allen key hole at the top.