I'm trying to set up two VLANs on a Powerconnect 3524 but I'm having trouble selecting the range of ports. I need two VLANs set up with 12 ports each.
I've typed in:
interface range ethernet 1/g1-1/g12
but I get
wrong number of parameters or invalid range, six or characters entered
How is my syntax wrong? I found a document entitled 'VLAN-Based Network Segregation' that is pretty helpful but it doesn't address the 35xx series powerconnects.
Here's the link to that document: http://www.dell.com/downloads/global/products/pwcnt/en/app_note_8.pdf
Anything help would be much appreciated.
You would need to enter the management vlan interface. Then exit back out to global to set the gateway if still needed.
console(config)# interface vlan 1
console(config-if)# ip address 192.168.1.2 /24
console(config)# ip default gateway 192.168.1.1 /24
Get Support on Twitter @DellCaresPro
Download the Dell Quick Resource Locator app today to access PowerEdge support content on your mobile device! (iOS, Android, Windows)
interface range ethernet 1/e1-12
interface range ethernet 1/g1-4
Both these commands are working on our test switch.
1. The switch is limited to just 4 possible Gigabit ports.
2. Leave out the 1/g on the end of the port range
Hope this helps,
Keep us updated.
Still getting the same message : | I had used the wizard to set up the inital ip, subnet, and gateway address. Perhaps, I need to start from fresh and avoid the set up wizard completely?
Yes, I would start over and not use the wizard. Also, I would recommend updating the firmware on the switch. Here is a link to the current firmware download.
I deleted the startup configuration, then proceeded to set up the switch again. Problem is when I'm not running the wizard I can't seem to set the ip and subnet for the switch itself. I see that in config mode you can use 'ip default-gateway' to set the default gateway but there isn't a command for setting the ip address. Where is this capability?
Thanks alot! I did get it set up correctly. FYI, to set up the ethernet range on the first vlan(after creating it) I had to input
interface range ethernet e1-24