I have a PowerConnect 6024 and Cisco ASA 5510 at the moment. I am trying to setup a few VLANs on the 6024 that will route between each other and outside of VLAN goes to the Cisco Firewall. Currently, I can do interVLAN communications but do not know how to insert the configurations for routing between the Dell switch and the Cisco Firewall.
I've setup the switch to
VLAN 2 /192.168.20.1 (trunked LAG port 3,4) => to linksys SRW2024 #1 (multipel VLAN configured)
VLAN 3 / 192.168.30.1 (trunked LAG port 5,6) => to linksys SRW2024 #2 (multipel VLAN configured)
VLAN 4 / 192.168.40.1 (trunked LAG port 7,8) => to linksys SRW2024 #3 (multipel VLAN configured)
Cisco's Inside Interface 192.168.20.250, Outside Interface 184.108.40.206 (fake number)
Current, interVLAN on any of the Linksys works but how do I setup to route to the Internet ?
I have seen that I need to use "Route IP x.x.x.x x.x.x.x y.y.y.y" but have no clue as to how or what.
IP route 192.168.0.0 255.255.0.0 192.168.20.250
That command should work for your environment, you may need to change the subnet if it does not work.
I think you could also use this command to route all traffic.
IP route 0.0.0.0 0.0.0.0 192.168.20.250
Keep us updated.
Learn more about Dell ProSupport
Get Support on Twitter @DellCaresPro
Download the Dell Quick Resource Locator app today to access PowerEdge support content on your mobile device! (iOS, Android, Windows)
The commands to add the IP routes would look something like this.
Dell-6024(config)# ip route 10.10.0.0 255.255.255.0 10.10.0.2
Dell-6024(config)# ip route 10.20.0.0 255.255.255.0 10.20.0.2
This article does a nice job of taking us through VLAN routing and how it is setup.
Page 183 starts the IP route
The following example establishes a static route to 172.16.0.0.
Console (config)# ip route 172.16.0.0 255.255.0.0 220.127.116.11
I hope this information helps out. Here is also another forum post where someone is attempting to the similar.
I've seen the article but do not know how it applies,
For example, how does "ip route 10.10.0.0 255.255.255.0 10.10.0.2" applies to my situation ?
ip route 192.168.10.0 255.255.255.0 192.168.10.2 (what is 192.168.10.2 ?)
What would be the static route look like in my environment ? is the 172.16.0.0 a VLAN and the 18.104.22.168 the inside interface on the Firewall ?
Another issues is where to plug in the firewall uplink ? I have a 254 VLAN trunked to another switch. Should I use like port 1 on the Dell to uplink to the Firewall and configure port 1 to be part of untagged 254 VLAN ?
I thought the above route command didn't work but the issues was the routes wasn't defined in the ASA !