I've got a new Studio 17 connected to my wireless network no problem. I just unpacked my new P703W printer - which looks great and prints great - but I can't get it to connect to my wireless network to save my life. It's within about 15 feet of the router. All of the information I have for the wireless connection is correct...but it won't connect!
Any ideas?! :-(
First, start out by fixing your wireless router using these settings.
Recommended Wireless Router Settings
Download the latest drivers
XP Drivers <ADMIN NOTE: Broken link has been removed / replaced from this post by Dell>
Vista 32-bit Drivers<ADMIN NOTE: Broken link has been removed / replaced from this post by Dell>
All other drivers
How Do I Connect a Dell™ Wireless Printer to a Wireless Network
Choose your printer. Beneath your printer, select your operating system. You'll be redirected to another page. Then click on show all steps. It will walk you through the installation process.
What is a Dell Service Tag and how do I locate it?
Original poster, If you have solved your problem, can you please mark the correct thread(s) with your solution. Thanks
Welcome to Dell Community!
#MicrosoftMVP - Windows Expert-Consumer April 1, 2012 to March 31, 2015
Well that'd be great, but I can't seem to get onto the page for my router. I have a linksys-G router and I've been to the linksys IP address to try to reset my settings, but I can't for the life of me get it to open. I use what I THINK the password is (all I know is admin admin) but it won't let me in. Is there any way to find out what my settings are? I wasn't the one who set up my network, but I know he didn't assign passwords to anything. It's very odd. :-(
Not sure what to do without getting the info I need to/from the router...
First, to get to the login page, try this.
Start, run or hit the Windows Key and the R key at the same time. Type
Hit enter. Now type
ipconfig /all (space between the g and / )
hit enter. Look for the default gateway. Enter this number in the address bar of your browser(Might look something like 192.168.1.1)
password= admin or leave it blank, unless you changed the password.
If you installed Linksys EasyLink Advisor, then you can open this program up. after it loads, click on the support tab and then wait. It will give you the password(s) you need. Then go to Linksys website (left column, enter model number in search box)and update the firmware for the wireless router. Model number needeed.
Broadcast SSID(You may want to change this to make it easier to connect)
Use WPA-PSK(TKIP) Security. Most wireless devices work best with this type of security.
Mixed b and g mode(n if available)
Use channels 1, 6 or 11. Most devices work better on these channels.
Save and exit. Power everything off for 30 seconds. Power everything back on, wait 30 seconds, now try to connect.
Now setup the printer.