Cpu Temerature after reflowing M5030

Laptop

Laptop
Laptop computer Hardware and Software discussion

Cpu Temerature after reflowing M5030

This question is not answered

Hi guys, 

After the 7 beeps issue i had reflow my Dell Insiron M5030 using no-clean flux and an air gun.

Before reassembling the heatsink i have used Antec Formula 7 thermal compound and then when the boot issue was solved i still have some temperature problems. 

As you can see in the image above, my cpu temperature is oscillating between 62°C and 74°C. 

I was wondering weather this behaviour is normal or if the temperature is higher than it should be.

Thanks in advance

Matias Andreoli

All Replies
  • Hi Matias Andreoli,

    The temperature oscillating between 60 to 70 degrees Celsius is normal as along as the air vents are not blocked. Make sure the system is placed on a flat surface where there is good air circulation.

    You have mentioned you are experiencing that the system is overheating. I would like to know if the system is very hot that you cannot touch it or if the system is just warm.  I would also like to know if the system is shutting down when the system overheats.

    Revert for any further queries.

    Thanks and Regards,
    Sujatha K
    #iworkfordell
    To know more about Dell Product Support, Drivers & Downloads, Order & Dispatch status -> choose your region US / India . For Dell support videos click here.

  • Dear Sujatha K,

    In response to your question, the system is warm and it doesn't turn off suddenly. 

    The first time I put all the parts together it suddenly shut down after approximately 5 minutes. This was solved when after i realize I have forgot to replace the old thermal compound.

    Another fact to take into account is that I have lost the original thermal pad placed in the gpu. I replace the pad adding thermal compound also to the gpu chip.

    I'm concern because the cpu temperature reaches very fast to 74ºC even though i'm not demanding to the processor any difficult task.

     

  • Does the heatsink fit flush with the heat slug on the CPU?  If there was a pad there before, there may be a gap that thermal compound can't fill - in which case you'll see ineffective cooling.

  • Hi, 

    Between the heat sink and the cpu there was always thermal compound. The pad I've mentioned was placed between the gpu and the heat sink. 

    I would like to replace the pad. However, I don't know the correct thickness. If you can give me some advice on what pad I have to buy I'd appreciate it.

    Thanks in advance

    Matias Andreoli

  • Hi Matias Andreoli,

    In this case you may have to take help from a local technician to know the thickness of the thermal pad.

    Thanks and Regards,
    Sujatha K
    #iworkfordell
    To know more about Dell Product Support, Drivers & Downloads, Order & Dispatch status -> choose your region US / India . For Dell support videos click here.