i replaced the PC2-533 4 gb memory with the PC2-667 4Gb memory and all my reporting programs still report a 266 MHZ memory speed.mine is a dell Optiplex GX620 USFF. It is running a P4 3.0 Ghz/800FSB/2Meg Cashe. Is this memory too much for this machine?
Your Optiplex specifies DDR2 PC2-5300, which should have an I/O bus clock speed of 333 MHz. So something is definitely not right. What is the make and part number of the new RAM? Did you purchase a matched set of 4x1GB modules?
Please post back and let me know if you need more help.
I have 2x2GB Avant AFV6456U61E5667F7 one is -WBXP the other is -MTGP.
Crucial the most recommend memory for Dell systems says it will only support 4 GB of PC2-5300 memory.
Home Built Sandy Bridge P8P67 i7 2600k @ 4.5 GHz 8gigs GSkill Ripjaws. Corsair 800D Case and AX1200 Ps X-Fi Titanium Fatal1ty pro PCIe Sound CardDell Studio XPS 1645 Window 10 Pro
Forum member since 2003
So can you suggest why it is still running at the 533 MHZ speed. i have updated the bios to the A11 version of dell Bios.
Because since it is not supported it will only run at slowest speed that the memory has programed into it. Memory if it posts and is not recognized by the bios will fall back to default settings.
Both the specs on the i945 express chipset and the users guide for the Optiplex GX620 USFF says it will support PC2-667. Are you saying that the Bios didn't recognize the speed change?
Then it is because the memory is mismatched. You stated previously that the numbers are different. Any mismatch in memory modules will cause the memory controller to become confused and it will throttle down to the slowest speed.
This is why is it important to buy the memory all at once in matched sets.
There are programs in each memory stick call SPD's these are programed by the manufacture and contain the operating parameters that the memory controller will read to utilize the memory in the system. And since manufactures will tweak these settings to enhance memory performance and stability across platforms any change between sticks will result in a mismatch as far as the controller is concerned
Try running with just one stick installed and see what it reports. I would do this with each stick. If each stick by itself works then you have a mismatch.
Each stick reports 266.1 MHZ memory speed pc2-5300 (333). the only difference between the two sticks is the letters at the end of the part number. The bios still reports a 533 MHZ memory speed.
This report came from CPUZ version 1.60 X64
The letters would be revision information by the vendor. My next thoughts is voltage requirements for the sticks. Dells are very finicky with memory.
go to the SPD tab on CPUZ and look at the JEDEC listings. compare those numbers to the vendors specs.
dell memory vendor specs or avant
The avant specs for these modules state 240-pin unbufferedn non-ecc DDR2 with 1.8v supply and timings of 5,.5,5,15 and 20. Exact to JEDEC specs #3.