Reboot and Select proper Boot device or Insert Boot Media in selected Boot Device & Press a Key

Desktop

Desktop
Desktop computer Hardware and Software discussion

Reboot and Select proper Boot device or Insert Boot Media in selected Boot Device & Press a Key

  • When I turn my computer it loads into a black screen that has text that says what's in my message subject. When I go into the bios setup, I look at the back of my computer 'light d' is yellow and it can't find either hard drive, but it can find the CD and DVD drives. Model - Dell Dimension 4500 2 Hard Drive Basic Setup.
  • First off, one little bit of information that might help is if the hard drives have a SATA interface or an IDE interface.  The second thing you want to check is if the jumper caps are set correctly on teh hard drives.  If you have two hard drives, then it is best to follow the configuration on the hard drive so the hard drive with the operating system is the master and have the second hard drive be the slave.  Because if both hard drives are set to master or both are set to slave, problems occur.
  • it's IDE
  • Okay then.  Most hard drives are set up so right next to the power socket is the pins for the jumper cap.  Somewhere on the hard drive should also be a sticker label that shows diagrams of different possible jumper cap combinations and what they mean.  There should be one configuration for master, one for slave, and another for cable/computer select.  These options might be abreviated on the lable.  Then look at what configuration your hard drives currently have.  Post them here if possible.  But basically look and make sure that one is master and the other is slave.  If it is on computer/cable select, then I am not really certain because technically the computer is supposed to be smart enough to figure out which hard drive to boot to, but I don't trust it and I always set one to master and the second to slave.  Just make sure the hard drive with the operating system is the one you set to master.
  • Looks like there is a small rip in my IDE cable, might be the problem.

    I've neglected this for some dumb reason....

    It was 3am a few nights ago and I was using the computer like I normally do, then I hit the side of my desktop, didn't seem like that hard of a hit as it's happened before but then the computer started making a noise. The noise has since stopped but now I'm at where I've been at.

    Message Edited by OldKai on 11-21-2007 12:41 AM