The pin assignment and connector for the motherboard in a Dell XP410 is standard USB and includes the following assignment:
 (Red) Power +5volts  (White) Data Negative  (Green) Data Positive  (Black) Ground  Unused
However, the Teac CA-200 Flash Card reader has a non standard 10 pin configuration (Flexbay connector 2.00 mm apart vs. 2.54mm apart). The pin assignments are as follows (back view connection of the Flash card reader) :
│ .R . .B .W . │
│ . . . . .G │
1st Row: Red, empty, Black, White, empty
2nd Row: empty, empty, empty, empty, Green
I tested this Flash Card reader in my XP410 and it works, but had to solder the pin connections in my card reader given the non standard connection. The XP410 motherboard uses the standard USB assignment and connector (pin layout above).
Hope this helps…
GO TO YOUR ONLINE COMPUTER DEALER LOOK FOR SUPPORT/DRIVERS THAN LOOK FOR THE MANUAL AND MAINTENCE FOR YOUR MODEL IT SHOULD GIVE YOU ALL THE INFOR U NEED
Many thanks to JUANJG115.
Soldered my own connection cable with this description, and it worked fine.
I had both the end-connection-plugs, but not the wiring.